NORSTAR BADGER SPOOLGUN AND SWITCH FOR MILLERMATIC 135 & 175 MIG WELDERS

NORSTAR BADGER SPOOLGUN AND SWITCH FOR MILLERMATIC 135 & 175 MIG WELDERS

( SWITCH IS SIMILAR TO A 300409 MILLER )

THIS KIT FITS THESE 2 MODELS 

INSTRUCTIONS ARE INCLUDED

REMOVE MM COVER 

UNPLUG THE DRIVE MOTOR FROM THE PC BOARD 

DRILL A HOLE FOR THE SWITCH INSIDE WHERE SHOWS

PLUG IN THE WHITE PLUGS ON THE SWITCH INTO THE PC BOARD AND THE DRIVE MOTOR PLUG

PLUG IN THE RED AND BLACK WIRES INTO THE EMPTY 2 PINS ON THE 4 PIN TRIGGER RECEPTACLE

IF THE SPOOLGUN RUNS BACKWARDS REVERSE THE RED AND BLACK WIRES ON THE SWITCH( NOT THE 4 PIN RECEPTACLE)

 

 

PURCHASE HERE AT WWW.BRWELDER.COM

Miller Millermatic 125 Hobby MIG Welder 907692

Miller Millermatic 125 Hobby MIG Welder 907692

Built for farm, home and light fabrication applications, the new Millermatic®125 Hobby from Miller Electric Mfg. Co. is an easy-to-use, beginner welder. The MIG and flux-cored-capable Millermatic 125 Hobby works off standard 115 V household power. It MIG welds 24 gauge to 1/8-inch material and welds 18 gauge to 3/16-inch material with flux-cored wire in a single pass. The machine’s simple two-knob design allows for easy setup and use. 

Comes Complete With

  • Millermatic 125 Power Source
  • Power cord with plug
  • 8 ft (2.4m) M-80 MIG gun and cable assembly
  • 8 ft (2.4m) work cable with clamp
  • Smith Argon and AR/CO2 mix regulator/flow gauge and gas hose
  • Two contact tips for .030 in (0.8 mm) wire
  • Quick Select drive roll for .024 in (0.6 mm) or .030/.035 in (0.8/0.9 mm) solid wire, and .030/.035 in (0.8/0.9 mm) flux-cored wire
  • Spool of Hobart .030 in solid wire
  • Material thickness gauge
  • Auto-Set automatically provides the right settings to weld mild steel while tapped voltage control allows the flexibility to manually set your own parameters.Angled cast-aluminum drive system with calibrated tension knob creates consistent feeding and easy setup
    • Turn the wire speed knob to Auto-Set, a blue light shows Auto-Set is activated
    • Dial in the thickness of what you’re welding
    • Start welding with the exact parameters you need
  • Quick Select drive roll makes setup quicker by offering three grooves – two for different size solid wire and a third for flux-cored wire
  • Factory-installed Gas Solenoid makes it easy to switch between MIG welding and flux-cored wire.
  • Thermal overload protection shuts down unit and activates the over temperature light if airflow is blocked or duty cycle is exceeded. Automatically resets when unit cools
  • Uses 4- or 8-inch (102 or 203mm) spools and can be set up to weld with .024-.030 inch (0.6-0.8 mm) solid wire and .030-.035 inch (0.8-0.9 mm) flux-cored wire

purchase here at www.brweldingsupplies.com