NORSTAR N810006 TROJAN SPOOLGUN HOBART ( HANDLER KIT)

NORSTAR N810006  TROJAN SPOOLGUN  HOBART  

INCLUDES KIT TO INSTALL ON HANDLER 135-140-175 & 180

 

MILLER/HOBART SPOOLGUN SWITCH KIT -SPOOLRUNNER 100 FOR HANDLER 135-175-140-180

 

 

Items need to hook up Hobart Spoolrunner 100 to Hobart Handler 135 , 140, 175 & 180 ( only)

 

Will not work on Handler 187

 

 

 

 

NORSTAR SPOOLGUN FOR HOBART HANDLER  

W / 1 LB SPOOL OF ALUMINUM WIRE

 

 

 

Features:

  • Weld aluminum, steel or stainless steel
  • .030″ – .035″ drive rolls
  • Standard M-10 style consumables
  • Uses standard 4″ wire spools

 

 

Items need to hook up Hobart Handler 135 , 140 , 180 & 175 ( only)

Will not work on Handler 187

 

 

 

REMOVE handler COVER 

UNPLUG THE DRIVE MOTOR FROM THE PC BOARD 

take out the black trigger plug  ( where the 2 spade connectors from the mig gun trigger plug in 

and put the switch there 

DRILL A HOLE FOR THE 4 pin receptacle ( sometimes behind the front cover there is a hole blocked off by the front nameplate )

INSTALL THE NEW CORD ON YOUR MIG GUN  

THE TWO WIRES THAT WERE IN THE BACK OF THE BLACK TRIGGER PLUG , INSTALL THE NEW PINS ON THESE WIRES AND INSTALL IN PINS 1 & 2 ON THE 4 PIN RECEPTACLE

 

PLUG IN THE WHITE PLUGS ON THE SWITCH INTO THE PC BOARD AND THE DRIVE MOTOR PLUG

PLUG IN THE RED AND BLACK WIRES INTO THE EMPTY 2 PINS ON THE 4 PIN TRIGGER RECEPTACLE ( pins 3 & 4)

IF THE SPOOLGUN RUNS BACKWARDS REVERSE THE RED AND BLACK WIRES ON THE SWITCH( NOT THE 4 PIN RECEPTACLE)

THIS IS NOT A MILLER SWITCH

 . If your  Serial# is LC175022 and above ( with the 2 pin square drive motor plugs)
the switch plugs into the harness . If it is a lower serial number , you have to do some wiring , but not hard to do)

 

purchase here